Audio-technica at-vm95ml element nieuwe serie!
- Ophalen of verzenden
VM95 series Microlinear stereo cartridge
The AT-VM95ML, features a Nude Microlinear diamond, not only the Microlinear stylus will permit to double the duration of your stylus.
The performance of a line contact stylus, will minimize the “inner groove distortion” as well as providing extended frequency response and maximize resolution in the medium and high frequencies of the audio program material.
- material. Aluminium cantilever
- 3.5mV output voltage
- Compatible body with all VM95 Series stylus assemblies
- 20 to 25,000Hz frequency response
VM95 Series - Styli compatibility
Every cartridge diamond stylus becomes worn after a period of play.
Around 500 hours for a conical stylus, 300 hours for an Elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 Series dual moving magnet cartridges can be used almost forever by replacing the interchangeable stylus.
It is no longer necessary to purchase a complete cartridge when your diamond is worn out, you can simply buy the matching replacement stylus, but also enjoy the experience of upgrading your cartridge with a different stylus.
The six models of VM95 Series cartridges all use the same electromagnetic engine-body, therefore each of the six replacement styli are perfectly compatible.
Microlinear StylusMicrolinear profile diamond stylus offers high frequency response with less wear and distortion than elliptical or conventional linear contact styli.
No use of nutsVM95 Series cartridges features two M2.6 threaded inserts allowing the installation of the cartridge onto tonearm or removable headshell without the use of nuts.
Each cartridge is provided with one pair of 8mm M2.6 screws, one pair of 11mm M2.6 screws and two plastic washers.
Cartridge EAN Code
VM Stereo Dual Magnet
20 - 25,000Hz
23 dB (1kHz)
Output Channel Balance
1.5 dB (1kHz)
3.5mV (1kHz, 5cm/sec.)
Vertical Tracking Angle
Vertical Tracking Force Range
1.8 – 2.2g (2.0g standard)
2.2 x 0.12 mil
Nude Square Shank
20 x 10-6 cm/dyne
10 x 10-6 cm/dyne (100Hz)
Wire Used For Coil
Recommended Load Impedance
Recommended Load Capacitance
100 – 200pF
550 mH (1kHz)
2 x M2.6 Treaded inserts
Replacement Stylus EAN Code
2x 11mm installation screws; 2x 8mm installation screws; 2x washers; non-magnetic screwdriver
17.2 (H) x 18.9 (W) x 28.3 (L) mm